30″ Dia. Single Tied Expansion Joint Designed for an Oil Refinery
6″ Dia. Single Expansion Joint Designed for a Pipeline in Texas
PTFE Coated Single Expansion Joints For A Power Plant in Mississippi
Double Arched PTFE-lined Rubber Expansion Joints for a Polysilicon Plant
10′ Long Expansion Joints Designed for a Nuclear Energy Facility
84″ & 14″ Dia. Single Expansion Joints Custom Designed for a Pipeline in a Utility Plant
U.S. Bellows, Inc. Designed and Fabricated a Single Expansion Joint Assembly for an Oil Refinery in South Africa
Single Expansion Joints Custom Designed for a Power Generation Application
Custom Single Expansion Joints for Oil Pipeline Application
U.S. Bellows Responds to Emergency Order for a 48″ Diameter Tied Single Expansion Joint
Single Expansion Joints Custom Designed for a Hydrocarbon Vapor Pump
16″ Dia. Stainless Steel Single Expansion Joints Designed for a Pipeline
Single Expansion Joints Manufactured for a Lab at Michigan State University
Single Expansion Joint
Single Expansion Joints
Tied Single Expansion Joint
Tied Single Expansion Joints
Single Tied Expansion Joint
Single Expansion Joint
Single Tied Expansion Joint
Metallic Expansion Joint
Metallic Expansion Joint with Carbon Steel Flanges
Single Flanged Metallic Expansion Joint
Metallic Expansion Joint
Single Metallic Expansion Joints with Limit Rods
HPIM0331.JPG
OLYMPUS DIGITAL CAMERA
OLYMPUS DIGITAL CAMERA
Single Expansion Joint
single hinged expansion joint
Single Expansion Joint
Single Expansion Joint
Single Expansion Joint
The photographs above show a double hinged expansion joint (figure 1) and a double gimbal expansion joint (figure 2) for a gas application at a project in Mexico. These uniquely designed expansion joints, bellows, flanges and pipes are fabricated from Inco. 800 H and designed at 60 psig and 1050oF. These expansion joints were 100 percent x-rayed and hydro-tested.
U.S. Bellows, Inc. designed and fabricated this expansion joint exhaust assembly for an oil refinery in Texas. This expansion joint is offset for an offshore platform and weighs approximately 8,000 lbs. It has a design pressure and temperature of 1 PSIG and 1000 degrees, respectively. The air test was conducted to detect any leaks.